Mercedes-Benz 2003 CL 55 AMG Manuel de l'opérateur télécharger pdf (Page 105)

105

Controls in detail

Memory function

Memory function

The memory button and stored position

switch are located on the door.

You can store up to three different settings

per SmartKey or KEYLESS-GO* card.

The following settings are saved for each

stored position:

앫 Driver’s seat and seat backrest posi-

tion

앫 Settings for multicontour seat*

앫 Steering wheel position

앫 Inside rear view mirror position

앫 Exterior rear view mirror position

앫 Automatic climate control

These key dependent memory settings can

be deactivated if desired (

컄 page 140).

1, 2, 3 Stored position button

M Memory button

왘 Make sure that the ignition is switched

on or the relevant door is open and the

SmartKey is inserted in the starter

switch.

!

Prior to operating the vehicle, the driv-

er should check and adjust the seat

height, seat position fore and aft, and

seat backrest angle if necessary, to en-

sure adequate control, reach and com-

fort. The head restraint should also be

adjusted for proper height. Also see

“Airbag” section (

컄 page 55) for proper

seat positioning.

In addition, adjust the steering wheel to

ensure adequate control, reach, opera-

tion and comfort. Both the inside and

outside rear view mirrors should be ad-

justed for adequate rear vision.

Fasten seat belts. Infants and small

children should be seated in a properly

secured restraint system that complies

with U.S. Federal Motor Vehicle Safety

Standards 213 and 225 and Canadian

Motor Vehicle Safety Standards 213

and 210.2.

Warning! G

Do not activate the memory function while

driving. Activating the memory function

while driving could cause the driver to lose

control of the vehicle.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 383 384

Commentaires sur ces manuels

Pas de commentaire